Discovery Sport Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 · (Edited)
Installed a front dashcam on my 2020 DS today. I didn't find any tutorials online for the facelift DS so I took a few pics of the tricky parts for the install. It took about 2.5 hours for the front as a guy who’s never worked on a LR before. I also have a rear cam that I didn't have time to do. I'll update this post when I have time to do the rear.

Step 1: Drink a beer
Step 2. Use a multimeter to find an always on fuse and an ignition fuse. I used the diagnostic socket (port 13) for always on and the auxiliary power socket (port 38) for the ignition. An issue I found with the aux power socket is the socket powers on when I open the door and stays on for (5?) minutes and powers off if I don't do anything. Additionally The aux power socket stays on for (5?) minutes after I turn off the car. I need to find a better fuse tap location that turns off with the ignition because I'm used to that on/off behavior. If I lock the car, the aux power turns off.
Font Parallel Rectangle Paper Document

Automotive design Audio equipment Motor vehicle Steering wheel Gauge


Step 3. I ran the wires out the side of the glove box and up the weather stripping. The weather stripping pulls off easily giving you access to the space behind it.

Side of glovebox. I used the glovebox bolt for my ground
Electrical wiring Hood Cable Gas Motor vehicle


weather stripping pulled away
Hood Motor vehicle Automotive lighting Vehicle Car


here I highlight my dashcam power line, taped down with electrical tape
Hood Automotive tire Automotive design Vehicle Motor vehicle


Step 4: You will need to remove the A pillar trim to pass the wire under the airbag. If you pass the wire over the airbag, there is potential for the airbag to not deploy correctly. To remove the trim, you can remove the plastic "Airbag" cover. Its not intuitive, but there is a metal V-shaped tab that holds the A-pillar trim to the A pillar, You can use a screwdriver and push the tab closed to pop it out of the pillar. I marked the direction to push the tab in the picture.
Automotive design Automotive exterior Vehicle Personal luxury car Rim

Cable Gadget Tints and shades Font Wire


The picture angle is all weird but that is the same tab from the back view. The blue circle is where it clips into the pillar
Hood Automotive lighting Automotive tire Motor vehicle Bumper


The path I ran the power cable. It tucks into the headliner between the windshield pretty easily
Automotive side-view mirror Vehicle Car Automotive lighting Hood


Step 8: attach your dashcam.
Automotive design Automotive side-view mirror Gadget Automotive lighting Display device


Step 9: drink a beer.

Cheers
 

· Registered
Joined
·
8 Posts
Discussion Starter · #2 · (Edited)
Spent a little time today to find a better ignition fuse tap. Changed the tap location to fuse 41 - Heated steering wheel. This location doesn’t power on when I open the door and it powers off 1 minute after turning off the ignition. I also don’t have a heated steering wheel
 
1 - 2 of 2 Posts
Top